General Information On The Electrical Connection - Viessmann VITOCAL 200-G Installation And Service Instructions Manual

General information on the electrical connection

■ Electrical connection of system
components (pumps, mixers, valves,
alarm facilities, contactors, function
extensions, sensors, etc.):
These connections are made inside
the heat pump control unit. Observe
information from page 39.
■ Power supply:
Siting
!
Please note
Avoid damaging the appliance
during transportation.
Never put weight on top of the
appliance.
Installation room requirements
!
Please note
The installation room must be dry
and free from the risk of frost.
Ensure ambient temperatures of
0 to 35 ºC.
!
Please note
Avoid risk of explosion due to
dust, gases and vapours
in the installation room.
Total weight
Output stage
06
08
10
13
17
The number of power cables from the
distribution board (meter box) to the
heat pump control unit and to the con-
trol panel depends on the system ver-
sion and tariffs used.
These connections are made inside
the heat pump control panel. Observe
information from page 52.
!
Please note
If the compressor is at a steep
angle in the heat pump, lubricant
will enter the refrigerant circuit
and damage the appliance.
Max. tilting angle 45°.
!
Please note
Observe the permissible floor
load.
See the following table, "Total
weight".
Type BWC 201.A
(400 V~ appliance)
113 kg
117 kg
129 kg
135 kg
148 kg
Preparing for installation
Type BWC-M 201.A
(230 V~ appliance)
115 kg
119 kg
131 kg
—
—
7