Table of Contents
Advertisement
5-3 Body-pack Transmitter // PT-36BG2
(1) Press the SET button to select between frequency /group/ sensitivity / RF outputs.
(depends on country)
1. Frequency adjusting
Press the UP or DOWN button to adjust the setting of a menu.
1-1 Hold SET button for 3 seconds to activate frequency.
1-2 Once you see "MHz" blanking , you are ready to select your desired frequency
by using UP and DOWN buttons.
1-3 Press the SET button again to store your changes.
2. Group adjusting
2-1 Press"Set" button
2-2 Presss" Up
2-3 Press "Set" again and the Channel (CH) will flash.
2-4 Press " Up" or "
2-5 After setting, press "Set" again to save the setting.
3. Sensitivity adjusting
3-1 Press the SET button twice to select sensitivity. Lasting for 3 seconds at the first
press, then 1 second for the second press, and the display appears
3-2 Use UP and DOWN buttons to adjust changes.
3-3 Finally press SET button again to store your changes.
4. RF Outputs adjusting
4-1 Push the "Set" button
4-2 Then push " Up
"
Down
4-3 Selectable transmission power betwem 10mW & 50mW.
4-4 Push the "Set" again to save the setting.
19
WIRELESS MICROPHONE SYSTEM
for 3 seconds, the group (G) will flash. (Figure 6)
22
" or " Down
23
Down" button to select a desired channel.
several times until the "rF Lo " or "rF Hi" flashes.
22
" to choose "Hi" for high transmitting power and push
23
"to choose "Lo" for low transmitting power.
24
Figure 6
"button to select a desired group.
24
3"
.
Advertisement
Table of Contents
