Internal Fx Send Controls - PRESONUS StudioLive 16.4.2 Owner's Manual

Owner's Manual

Internal FX Send Controls

4.4.2
Mute Button
Post-Fader Send Button
Output Level Control
Internal Effects Send
Select Button
Mix Button
Mutes and Unmutes the Internal Effects Bus.
This button will mute or unmute its internal effects (EFX) bus. It will illuminate red
when the bus is muted.
Enables and Disables Post-Fader Send.
By default, this button is enabled, and the send levels to the effects buses are
post-EQ, post-dynamics processing, and post-fader and therefore are affected by
fader settings. If the button is disabled, by default, the EFX sends use the Pre 2
setting, in which the sends are post-EQ and post-dynamics but pre-fader. However, in
the System Menu, you can switch the EFX sends to the Pre 1 setting, in which the
sends are pre-fader and pre-Fat Channel dynamics processing and EQ. Please review
Section 5.4 for details.
Adjusts the Master Level of the Effects Send.
This knob controls the overall output level of the internal effects mix.
Enables Fat Channel Viewing.
As described in section 4.1.1, the Select button routes its Effects bus through the Fat
Channel, allowing you to add dynamics processing and EQ. From the Fat Channel,
you can also route each Effects bus to the Subgroups or Mains. By default, both FXA
and FXB are routed to the Main bus.
Enables Aux Bus Mixing and Metering in the Fat Channel.
When this button is enabled, the 16 encoders in the Fat Channel become the
effects-send level controls for each of their respective input channels. The meters will
display the send level of each of the input channels.
Controls 4
Aux and FX Buses 4.4
37 37 37