PRESONUS StudioLive 16.4.2 Owner's Manual page 84

7 Software: Universal Control, SL Remote, Capture, Studio One Artist
7.2 Virtual StudioLive
Aux Send View
mix, use your mouse to set the send level for Channel 1. Right-click on the Channel
1 send level and sweep your mouse across the other channel sends for that Aux.
The set send level will be copied to every other channel for that Aux.
Masters View
GEQ in Focus
78 78
VSL provides two views for your StudioLive Aux
Outputs and FX Buses. The Aux Send View gives you
an overview of the send levels of every channel on
your StudioLive to every Aux Output and FX Bus.
Clicking in the arrow button will collapse the
Auxes, allowing you to view channel faders
instead of knobs on lower-resolution screens.
Power User Tip: To quickly set up an aux
The Masters View displays the controls for each Aux
Output and FX bus, just as they are on your StudioLive.
The Masters View also displays the send levels for the
Aux Flip Mode Channels (Main FireWire Return, Tape
Input, Aux In A and B, FXA, and FXB). From within the
Masters View, you can also select each Aux and FX bus
to edit its Fat Channel insert.
In general, most Graphic EQ settings will be created prior to a live show
and will not be adjusted after that. However, sometimes minor
adjustments must be made later. VSL makes this quick and easy. You will
have noticed that there is a GEQ above the Master section on the
Overview tab. You can focus any GEQ here by one of two ways:
• Select a GEQ on the GEQ Tab. For example, if you leave GEQ 5/6 in focus
on the GEQ tab and switch back over to the Overview tab, you will still be
able to adjust it using the Focus GEQ above the Master Section.
• Select the GEQ from the GEQ Focus Menu. In the upper left corner of
GEQ in Focus, you will find a pull-down menu. From this menu, you can
select any of the eight mono GEQs to put into focus on the Overview tab.
PreSonus StudioLive 16.4.2
™