Table of Contents
Advertisement
8.12
Program example 2
145min
Segment 1
Segment 2
Time
Dwell
Duration 2:25:00hrs
Duration 1:00:00
(rate 500°C/hr)
MW power
Target 1200°C
90% fixed
100% fixed
MW power
50% variable
The following sequence of entries creates and runs the 5 segment program shown in figure 8.2
above. If a multi program controller is fitted, another program can be run within this by
activating it with a 'Call' segment (segment 3 of this program). In segments 1 and 5 the
microwave power percentage setting comes from the microwave control page, it can be
changed while the program is running. The microwave control timer does not need to be
running for a program to use this power setting.
On the home page:
Press down
Press page
3 times to get to the MW control page.
Press up
down
can be manually adjusted while a program is running.
Check that the microwave count down timer is switched off and or down to zero:
Press scroll
Press scroll
If you want the MW power to pulse on/off in the segments:
Press scroll
Press scroll
Press scroll
Return to the home page then go to the Program Edit page:
Press page
and scroll
Press page
twice.
On multi-program models:
Press up
or down
segment).
Now enter the parameters for the program segments:
30
Multi prog
units only
60min
Program 3
example
1200°C
Segment 3
Call
Call prog 3
Call cycles 2
Figure 8.2 Program example 2
to turn the controller SP down to '-20'.
to set the power to 50%. Segments 1 and 5 will use this setting. It
then down
to set the time to zero.
then press up
or down
then press up
or down
then up
or down
then up
or down
at the same time.
to select a new program number, (a program with only 1
Natural cool down to 803°C
Segment 4
Holdback
Step
High 3°C
Target 800°C
Holdback
3°C High
MW power
90% fixed
100% fixed
to set the timer to 'off'.
to set to '1' for 'on'.
to set to the 'on' duration.
to set to the 'off' duration.
Continuous dwell at 800°C
800°C
Segment 5
End Type Dwell
MW power
50% variable
MF 55-GB 1.21
MRF 16/22
Advertisement
Table of Contents
