Table of Contents
Advertisement
MRF 16/22
running. A program can be edited while it is running. Changes made to the current segment
will not take effect until next time it is run; changes made to further segments will take effect in
the current program run.
Figure 5.1 Control panel
Main controller Eurotherm 3508
Currently showing the home page:
Measured temperature 313°C
Setpoint temperature 1500°C
Microwave power % zero
[See section 4.5 for notes about
notes about measurement at
ambient temperature]
Over temperature limit controller
Eurotherm 2132 set at 1625°C
[See section 10]
Supply light and instrument switch
When the furnace is connected to
the electrical supply the light
will glow green
Heat light(s). When power is
supplied to
the elements the light(s) will glow
amber.
Brightness will vary with power
Thermal cut-out fault light will
glow red in a fault condition
MW power ON light. When power
is supplied to the elements the
light will glow amber. Brightness
will vary with power percentage
MW circuit failure light will
glow red in a fault condition
Figure 5.1 Control Panel
18
MF 55-GB 1.21
Advertisement
Table of Contents
