Table of Contents
Advertisement
8.4
To pause (hold) a program
Press RUN/HOLD once.
8.5
To stop and reset a program
Press RUN/HOLD once, then press again and hold for 2 seconds.
8.6
To run a different program
To select a program:
From the home page, press page
Press up
to select a program number.
Start the program by pressing RUN/HOLD twice.
8.7
Program cycling
The Cycles parameter sets the number of times the program will run.
The default setting is 1 cycle.
To change the number of cycles, press page
shows "Cycles", then press up
to set cycling to continuous.
8.8
Program status
While a program is running the home display shows several values [See figure 5.2]:
OP1: Element power on
1:
MW power on. Percentage level as set on the Microwave control page.
1 2:
MW power on. Percentage level as set for the program segment.
Measured temperature
Program setpoint temperature (PSP)
MW power percentage
To see more detail:
Press page
once to go to the program status page. The measured temperature remains on
the top of the screen. The lower half of the screen now shows:
Current program number
Press
to view the current segment number and type
Press
to view the time remaining for that segment
Press
to view the status. This can be changed to Hold, Reset or Run by pressing up
down
.
Press
to view the program setpoint (PSP)
Press
to view the current Segment Type. Step and Call segments are instant, so are only
flashed on the screen, unless Holdback is operating on that segment.
Press
to view the target Setpoint
Press
to view the segment Rate
Press
to view the cycles left
Press
to view the events
Press
to view the program Time Left
26
once to get to the Program Status page.
twice, then press scroll
to set a finite number of cycles up to 999. Or press down
For Rate, Time and Step segments only
MRF 16/22
until the display
or
MF 55-GB 1.21
Advertisement
Table of Contents
