Table of Contents
Advertisement
17 Glossary of terms
Call
Dwell
Element
End
Holdback
Home display
MAT
Measured
temperature
MW
PID
Parameter
Program
Program setpoint
temperature (PSP)
Ramp
Rate
Reset
Segment
Setpoint
temperature (SP)
Step
Thermocouple
Time
MF 55-GB 1.21
Interrupts a program to run another program, then returns to
continue
Time period during which the PSP is fixed.
The heating device used in the furnace or oven.
A segment type to end a program by either: Going into Reset and
controlling to the SP. Or to Dwell at the last PSP value until Reset is
pressed.
Holdback prevents the PSP from running ahead of the actual
heating or cooling.
The first display of the controller screen, to which it returns when no
keys are pressed.
Microwave Assist Technology
The temperature sensed by the control thermocouple.
Microwave
Proportional, Integral, Derivative: the control system used by the
controller.
A temperature or time value, or program action.
A pre-set sequence of segments to control temperature changes
and time periods.
The target temperature as a program proceeds.
A period of time during which the Program Setpoint temperature
rises or falls
The rate; in degrees per second, min or hour, of the Program
Setpoint temperature rise or fall.
A single action by the operator to stop a program running and return
to simple controller mode.
A program section in which a group of parameters are set.
The target temperature when operating as a controller.
An immediate rise or fall in the Program Setpoint temperature.
The temperature sensing device used in the furnace.
A set time period for the Program Setpoint temperature to rise or fall.
MRF 16/22
51
Advertisement
Table of Contents
