On-Demand Staging; Activesync Connection Mode; Already Existing Ip Connection Mode; Well-Known Wlan Connection Mode - Motorola MC17 Product Reference Manual

2 - 4 MC17/MC17T Product Reference Guide

On-Demand Staging

The MSP 3.0
RD Client
Staging (Electronic Staging).
When using On-Demand Staging, the RD Client pulls staging profiles directly from an On-Demand Profile Server
over some form of pre-configured or automatically-configured IP connection. The following types of IP connection
modes are currently supported for Electronic Staging:

ActiveSync Connection Mode

This mode uses the IP connection that is established when the mobile computer is directly connected (via a USB
cable, serial cable or cradle) to a host computer running ActiveSync. The most common scenario would be where
the On-Demand Profile Server is running on the host computer to which the mobile computer is connected via
ActiveSync. It would, however, also work with the On-Demand Profile Server running on any other host computer
that is on the same subnet as the host computer to which the mobile computer is connected via ActiveSync.

Already existing IP Connection Mode

This mode uses any IP connection that is already active on the mobile computer. This could be a direct Ethernet
port (if available), or a WLAN connection that was configured and established before the
could also be any other form of IP connection that might be available on the mobile computer. The
not do anything to configure or establish such connections, but uses them if they exist. The On-Demand Profile
Server must be running on a host computer that is on the same subnet that is accessible from the connection.

Well-known WLAN Connection Mode

This mode works only on supported Motorola WLAN adapters. The
WLAN IP connections using pre-defined Motorola WLAN settings. If the
and establish such a connection, and if an On-Demand Profile Server is running on a host computer that is on the
same subnet that is accessible from the connection, then Electronic Staging proceeds using that connection.
To perform On-Demand Staging:
In the
1. App Launcher
window displays.
Waiting for Bar Codes
Figure 2-6
Press the left function key to select
2.
also enables staging without having to scan bar codes through the use of On-Demand
menu, press the center function key to launch the
. The
Options
attempts to configure and establish
RD Client
RD Client
RD Client
window appears.
Main Menu
was launched. It
RD Client
RD Client
is able to successfully configure
. The
Scan Barcodes To Deploy
does