Configuring The Security Mode - Cisco RV130 Administration Manual

Configuring Wireless Networks
Configuring Basic Wireless Settings
STEP 4
NOTE
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide
Enable SSID
SSID Name
SSID Broadcast
Security Mode
MAC Filter
VLAN
Wireless Isolation with SSID
WMM (Wi-Fi Multimedia)
Max Associated Clients
WPS
Portal Profile
Click Save.

Configuring the Security Mode

You can configure one of the following security modes for wireless networks:
Configuring WEP
The WEP security mode offers weak security with a basic encryption method that
is not as secure as WPA. WEP may be required if your network devices do not
support WPA.
If you do not have to use WEP, we recommend that you use WPA2. If you are using
the Wireless-N only mode, you must use WPA2.
Click On to enable the network.
Enter the name of the network.
Check this box to enable SSID broadcast. If
SSID broadcast is enabled, the wireless router
advertises its availability to wireless-equipped
devices in the range of the router.
See Configuring the Security
See Configuring MAC
Choose the VLAN associated with the network.
Check this box to enable wireless isolation
within the SSID.
Check this box to enable WMM.
The maximum number of clients that can
connect to the selected wireless network. Enter
a number between 1 and 64.
Check this box to map the device WPS button
on the front panel to this network.
See Configuring Captive
4
Mode.
Filtering.
Portal.
64