Configuring Rstp - Cisco RV130 Administration Manual

Configuring Networking
Configuring LAN Settings
STEP 3
STEP 4
STEP 5
STEP 1
STEP 2
Cisco RV130/RV130W Wireless Multifunction VPN Router Administration Guide
From the VLAN drop-down menu, choose the ID of the VLAN where DMZ is
enabled.
In the Host IP Address field, enter the IP address of the DMZ host. The DMZ host
is the endpoint that receives the redirected packets.
Click Save.

Configuring RSTP

Rapid Spanning Tree Protocol (RSTP) is a network protocol that prevents loops in
the network and dynamically reconfigures which physical links should forward
frames. To configure Rapid Spanning Tree Protocol (RTSP):
Choose Networking > LAN > RSTP.
Enter the following information:
System Priority
Hello Time
Max Age
Choose the system priority from the drop-down
menu. You can choose from a system priority from
0 to 61440 in increments of 4096. Valid values are
0, 4096, 8192, 12288, 16384, 20480, 24576,
28672, 32768, 40960, 45056, 49152, 53248,
57344, and 61440.
The lower the system priority, the more likely the
device is to become the root in the spanning tree.
The default is 327688.
The hello time is the time period that the root of the
spanning tree waits before sending hello
messages. Enter a number from 1 to 10. The default
is 2.
The max age is the time period that the router waits
to receive a hello message. If the max age is
reached, the router tries to change the spanning
tree. Enter a number from 6 to 40. The default is 20.
3
35