Configuring Bandwidth Priority - Cisco RV130 Administration Manual

Configuring Quality of Service (QoS)
Configuring Bandwidth Management
STEP 4
STEP 1
STEP 2
Cisco RV130/130W Wireless Multifunction VPN Router Administration Guide
Downstream
Click Save.

Configuring Bandwidth Priority

In the Bandwidth Priority Table, you can assign priorities to services to manage
bandwidth usage.
To configure bandwidth priority:
In the Bandwidth Priority Table, click Add Row.
Enter information in the following fields:
Enable
Direction
Category
Service
VLAN/SSID
IP Address
Subnet Mask
Priority
Remarking
The bandwidth (kb/s) used for receiving data from
the Internet. (Applies to the default VLAN only)
Check to enable bandwidth management for this
service.
Choose if you want to set priority for inbound or
outbound traffic.
Choose if you want to set bandwidth priority for a
service, VLAN/SSID, Source IP (inbound traffic), or
Destination IP (outbound traffic).
Choose the service to prioritize.
Choose the VLAN or SSID for which you want to
set priority.
If you select Source IP or Destination IP in the
Category field, enter the IP address and the subnet
mask of the source or destination.
Set the priority (low, medium, or high) for the
selected category.
Check to enable remarking on Differentiated
Services Code Point (DSCP). Enabling this feature
prioritizes the network traffic across the LAN
based on the DSCP queue mapping on the DSCP
Settings page.
7
111