Adding Access Rules - Cisco RV130 Administration Manual

Configuring the Firewall
Configuring Access Rules
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV130/130W Wireless Multifunction VPN Router Administration Guide

Adding Access Rules

All configured firewall rules on the device are displayed in the Access Rules
Table. This list also indicates whether the rule is enabled (active) and gives a
summary of the From/To zone as well as the services and users the rule affects.
To create an access rule:
Choose Firewall > Access Rules.
Click Add Row.
In the Connection Type field, choose the source of originating traffic:
• Outbound (LAN > WAN)—Choose this option to create an outbound rule.
• Inbound (WAN > LAN)—Choose this option to create an inbound rule.
• Inbound (WAN > DMZ)—Choose this option to create an inbound rule.
From the Action drop-down menu, choose the action:
• Always Block—Always block the selected type of traffic.
• Always Allow—Never block the selected type of traffic.
• Block by schedule—Blocks the selected type of traffic according to a
schedule.
• Allow by schedule—Allows the selected type of traffic according to a
schedule.
From the Services drop-down menu, choose the service to allow or block for this
rule. Choose All Traffic to allow the rule to apply to all applications and services,
or choose a single application to block:
• Domain Name System (DNS), UDP or TCP
• File Transfer Protocol (FTP)
• Hyptertext Transfer Protocol (HTTP)
• Secure Hypertext Transfer Protocol (HTTPS)
• Trivial File Transfer Protocol (TFTP)
• Internet Message Access Protocol (IMAP)
• Network News Transport Protocol (NNTP)
5
90