Engine Oil Filter (Auxiliary) - Change; Engine Oil Level - Check; Every 500 Service Hours Engine Oil Filter (Auxiliary) - Change - Perkins 4016-61 TRG Operation And Maintenance Manual

SEBU8604
•
Loose bolts
•
Deterioration of the isolators
Ensure that the mounting bolts are tightened to the
correct torque.
Ensure that the isolators are free of oil and
contamination. Inspect the isolators for deterioration.
Ensure that the bolts for the isolators are tightened to
the correct torque.
Replace any isolator that shows deterioration. For
more information, see the literature that is provided
by the OEM of the isolators.
Engine Oil Filter (Auxiliary) -
Change
Note: Refer to the Operation and Maintenance
Manual, "Engine Oil Sample - Obtain" before
performing maintenance.
Change the Filter with the Engine
in Operation
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
Illustration 54
Typical example
The changeover valve (1) has three positions.
•
(A) The oil flow is to both oil filters.
•
(B) The oil flow is to the left hand oil filter.
•
(C) The oil flow is to the right hand oil filter.
1. Rotate the changeover valve to position B. By
using a suitable tool (2), remove the right hand
oil filter.
Note: Oil flow direction (D and E ).
2. Ensure that the sealing face on the housing is
clean. Fill the new oil filter with clean engine oil.
Install the new oil filter. Rotate the changeover
i02472513
valve to position A. Check for oil leaks.
3. Rotate the changeover valve to position C. By
using a suitable tool, remove the left hand oil filter.
4. Ensure that the sealing face on the housing is
clean. Fill the new oil filter with clean engine oil.
Install the new oil filter. Apply hand pressure
only in order to install the oil filter. Rotate the
changeover valve to position A. Check for oil
leaks.
5. Clean any spillage of engine oil.

Engine Oil Level - Check

Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
Perform this maintenance with the engine stopped.
Note: After the engine has been switched OFF, wait
for ten minutes in order to allow the engine oil to drain
to the oil pan before checking the oil level.
Operating your engine when the oil level is above the
"Max" mark could cause your crankshaft to dip into
the oil. The air bubbles created from the crankshaft
dipping into the oil reduces the oil's lubricating char-
acteristics and could result in the loss of power.
g01233078
Maintenance Section

Engine Oil Filter (Auxiliary) - Change

NOTICE
NOTICE
57
i02415261