Engine Oil Filter (Auxiliary) - Change; Engine Mounts - Inspect - Perkins 4016-61 TRG Operation And Maintenance Manual

SEBU8604-02
Illustration 64
Typical example
2. Remove the wing nut (1) and the cover (2).
3. Remove the filter elements (3) from the breather
body (5).
4. Clean the filter elements (3) and dry the filter
elements. Inspect the filter elements for damage
or deterioration. If necessary, replace the filter
elements.
5. Install the filter elements (3) to the breather body
(5).
6. Ensure that the seal in the cover (2) is free from
damage. If necessary, replace the seal.
7. Align the cover (2) with the dowel (4). Install the
cover to the breather body (5).
8. Install the wing nut (1). Tighten the wing nut
securely.
9. Restore the electrical supply to the starting motor.

Engine Mounts - Inspect

Misalignment of the engine and the driven equipment
will cause extensive damage. Excessive vibration
can lead to misalignment. Excessive vibration of the
engine and the driven equipment can be caused by
the following conditions:
• Improper mounting
• Loose bolts
• Deterioration of the isolators
Ensure that the mounting bolts are tightened to the
correct torque.
Ensure that the isolators are free of oil and
contamination. Inspect the isolators for deterioration.
Ensure that the bolts for the isolators are tightened to
the correct torque.
Replace any isolator that shows deterioration. For
more information, see the literature that is provided
by the OEM of the isolators.
Engine Oil Filter (Auxiliary) -
Change
Note: Refer to the Operation and Maintenance
Manual, "Engine Oil Sample - Obtain" before
performing maintenance.
g02117753
Change the Filter with the Engine
in Operation
Hot oil and hot components can cause personal
injury. Do not allow hot oil or hot components to
contact the skin.
i02415257
Illustration 65
Typical example
The changeover valve (1) has three positions.
69
Maintenance Section

Engine Mounts - Inspect

i04631322
g02775859