Function Priority; Using The Visca Rs-422 Connector Plug - Sony BRC Series System Manual

14.7 Function priority

This table shows which setting takes priority over the other in each function when the
BRC-H900/BRC-H700/BRC-Z700/BRC-Z330/BRC-300/300P is connected to the BRU-SF10/BRU-H700/BRU-
300/300P.
RS-232C/RS-422 control
DATA MIX setting
VISCA ID setting
VIDEO OUT
* The camera number setting at camera unit should be 0 (Auto).
To assign VISCA ID to each camera, please set it on BRU side.

14.8 Using the VISCA RS-422 Connector Plug

1
Insert a wire (AWG Nos. 28 to 18) into the desired
wire opening on the VISCA RS-422 connector
plug, and tighten the screw for that wire using a
flathead screwdriver.
Wire
2
Insert the VISCA RS-422 connector plug into the
VISCA RS-422 connector.
BRC cameras BRU
disable enable
disable enable
disable* enable
enable enable
Flat-head screwdriver
To remove the connector plug
Grasp both ends of the VISCA RS-422 connector
plug and pull it out as shown in the illustration.
• In order to stabilize the voltage level of the signal,
Note
connect both ends to GND.
• When you make connections using VISCA RS-422
connectors, the VISCA RS-232C connection is not
available.
• The maximum connection distance with VISCA
RS-422 connection is approximately 1,200 m
(3,937 ft).
61
Techinical Appendix