Optical Multiplex Units; Bru-Sf10 Hd Optical Multiplex Unit For Use With The Brc-H900 And Brc-Z330 - Sony BRC Series System Manual

Bottom
12
Ceiling bracket mounting screw holes
12
Tripod screw holes
13
BOTTOM switches
14
Setting of the BOTTOM switches
1 O
N
2
3
4
1 O
N
2
3
4
Switch 1
(No connection)
1
Always keep it OFF.

5.2 Optical Multiplex Units

The following provides information on the location and function of BRU-SF10, BRU-H700 and BRU-300/300P
parts.
With these optical multiplex units, you can transmit uncompressed digital data including video, external
sync, and camera control signals.
5.2.1 BRU-SF10 HD Optical Multiplex
Unit for use with the BRC-H900
and BRC-Z330
Rear
1 2 3 4
IN OUT
EXT SYNC RGB/COMPONENT
CAMERA
11
13 14
(1/4-20UNC)
1
2
3
4
5
5 6 7 8
IN OUT
1 2 3 4 5 6 7 8 9
VISCA RS232C
VISCA RS422
AUDIO OUT
L
FUNCTION
R 1
10
DC 12V
10 9
Switch 2
(RS-232C/RS-422 selector)
2
Set to ON for RS-422, or OFF for RS-232C.
Switch 3
(Communication baud rate selector)
3
Set to ON for 38400 bps, or OFF for 9600 bps.
Switch 4
(Infrared signal output switch)
4
Set to ON to enable an infrared signal output,
or OFF to disable the output.
Camera address selectors
5
Set the address of the camera. Normally set to
0. With this setting, addresses are assigned to
the cameras automatically in the connected
order by pressing the POWER button while
holding down the RESET button on the
RM-BR300 Remote Control Unit. You can assign
the camera address, 1 to 7, manually by setting
these selectors as follows:
Camera
0 1 2
address
Switch 1 OFF ON OFF
Switch 2 OFF
OFF ON
Switch 3 OFF OFF OFF
Please note that the same camera address
Note
cannot be assigned to two or more different
cameras. Furthermore, you must set the switches
before you turn on camera power.
CAMERA connector
1
EXT SYNC IN connector
2
EXT SYNC OUT connector
3
RGB/COMPONENT connector
4
Pin No. Signal Pin No.
1 Pr/R 9
2 10
Y/G
3 Pb/B 11
4 GND 12
5 GND 13
6 14
GND
7 GND 15
8 GND
3 4 5 6 7
ON OFF ON OFF ON
ON OFF OFF ON ON
OFF ON ON ON ON
Switch 4 is not used.
Signal
NC
GND
GND
NC
HD-OUT
Tri-level Sync/Bi-level VD
NC
21
Location and Function of Parts