Reset switch
2
If you press down this switch with a pointed tip
for about five seconds, the camera will reboot
and the IP control card BRBK-IP7Z will return to
the factory setting.
Factory settings for BRBK-IP7Z
• IP address: 192.168.0.100
• Subnet mask: 255.255.255.0
• Name: CAM1
SDI 1, 2 connectors (BNC type)
3
Supplies down-converted SD-SDI signals that
conform to the SMPTE259M serial digital
interface standards, or HD-SDI signals that
conform to the SMPTE292 serial digital interface
standards. Select HD-SDI or SD-SDI signals with
the
HD/SD select switch.
4
HD/SD select switch
4
The SD setting supplies SD-SDI signals and the
HD setting supplies HD-SDI signals.
Note • SD-SDI and HD-SDI signals cannot be supplied
simultaneously.
• Set the SD/HD select switch before turning on
the camera.
• Do not push the switch forcibly with a screw-
driver, etc.
29
Location and Function of Parts