Brbk-Mf1 Hd Optical Multiplex Card; Brbk-Hsd1 Hd/Sd-Sdi Output Card; Brbk-Hd2 Hd-Sdi Output Card; Brbk-303 Optical Multiplex Card - Sony BRC Series System Manual

5.3.6 BRBK-MF1 HD Optical
Multiplex Card
1
AUDIO IN L/R jacks
1
Input an audio signal (stereo), which is output
from the AUDIO OUT jacks on the BRU-H700 HD
Optical Multiplex Unit via an optical fiber cable.
The time difference between video and audio
can be adjusted by up to 240 ms by 10
ncrements.
The audio input on this board accepts audio line
Note
signals only. When you input audio signals from a
microphone or similar device, it should be
connected with a microphone amplifier so that
audio signals with an appropriate audio level
can be input.
Optical connector
2
5.3.7 BRBK-HSD1 HD/SD-SDI Output
Card
1
BRBK-HSD1
SDI OUTPUT
SDI OUTPUT connectors
1
Supplies down-converted SD-SDI signals that
conform to SMPTE259M (for 59.94i signal
format) and ITU-R BT.656 (50i signal format)
serial digital interface standards, and HD-SDI
signals that conform to the SMPTE292M serial
digital interface standard. Select HD-SDI or
SD-SDI signals with the HD/SD select switch.
HD/SD select switch
2
Set the switch to SD to supply SD-SDI signals
and HD to supply HD-SDI signals.
• SD-SDI and HD-SDI signals cannot be supplied
Note
simultaneously.
• Set the SD/HD select switch before turning on
the camera.
26
Location and Function of Parts
2
(phono-type)
2
SD HD
(BNC-type)
5.3.8 BRBK-HD2 HD-SDI Output
Card
1
SDI OUTPUT connectors
1
The Card allows output of an HD-SDI signal
conforming to SMPTE292M serial digital interface
standards. No audio signal is output from the
card.
5.3.9 BRBK-303 Optical Multiplex
Card
Optical connector
1
5.3.10 BRBK-301 Analog RGB
Component Card
1
RGB/SYNC connector
1
Pin No. Signal
1 GND
2 GND
3 R/Cr
4 G/ Y
5 B/Cb

5.3.11 BRBK-302 SDI Card

SDI connector
1
Supplies a signal conforming to the SMPTE259M
serial digital interface standard.
(BNC-type)
1
Pin No. Signal
6 Composite/Y
7 SYNC
8 GND
9 -/C
1