Location And Function Of Parts; Brc Series Of Cameras; Brc-H900 - Sony BRC Series System Manual

5

Location and Function of Parts

5.1 BRC Series of Cameras

The following is a summary of the location and function of BRC-H900, BRC-H700, BRC-Z700, BRC-Z330, and
BRC-300/300P parts.

5.1.1 BRC-H900

Rear
1 2 3 4
1 2 3
1 2 3 4 5 6 7 8 9
IR SELECT
VISCA RS-422 OFF ON
75
IN VISCA RS-232 OUT EXT SYNC IN VIDEO
7 8 9 10 11 12 13 14
VISCA RS-422 connector
1
75 Ω termination switch
2
This switch is used when an external sync signal
is used. Set it to OFF when this camera is in the
middle of a daisy-chain connection of multiple
cameras. Set it to ON when the camera is at the
end of a daisy-chain connection or when
nothing is connected to the EXT SYNC IN
connector on the camera.
IR SELECT switch
3
Select the camera number when you operate
multiple cameras with the same Remote
Commander.
Remote sensor
4
This is the sensor for the supplied Remote
Commander.
This remote sensor does not function when IMG
FLIP is set to ON in the SYSTEM menu.
HD/SD select switch
5
Outputs an SD-SDI signal from the SDI
connector when the switch is set to SD, or an
HD-SDI signal from the SDI connector when the
switch is set to HD.
Set the switch before turning the camera on.
Note
14
Location and Function of Parts
5 6
HD SD
RGB/COMPONENT
DC IN 12V
S VIDEO SDI OUT
RGB/COMPONENT connector
6
Pin No. Signal Pin No.
1 Pr/R 9
2 Y/G 10
3 Pb/B 11
4 GND 12
5 GND 13
6 GND 14
7 GND 15
8 GND
VISCA RS-232C IN connector
7
Connect to the RM-BR300 Remote Control Unit
(not supplied). When you connect multiple
cameras, connect it to the VISCA RS-232C OUT
connector of the previous camera in a daisy-
chain connection.
VISCA RS-232C OUT connector
8
When you connect multiple cameras, connect
it to the VISCA RS-232C IN connector of the next
camera in a daisy-chain connection.
EXT SYNC IN connector
9
VIDEO connector
10
S VIDEO connector
11
SDI connector
12
Outputs the video signal from the camera as
an HD/SD-SDI signal.
Supplies down-converted SD-SDI signals that
conform to the SMPTE 259M serial digital
interface standards, or HD-SDI signals that
conform to the SMPTE 292 serial digital interface
standards. Select HD-SDI or SD-SDI signals with
the HD/SD select switch.
Card slot
13
DC IN 12V connector
14
Signal
NC
GND
GND
NC
HD-OUT
Tri-level Sync/Bi-level VD
NC