Bru-H700 Hd Optical Multiplex Unit For Use With The Brc-H700 And Brc-Z700 - Sony BRC Series System Manual

5.2.2 BRU-H700 HD Optical Multiplex
Unit for use with the BRC-H700
and BRC-Z700
Rear
1
IN EXT SYNC OUT RGB/COMPONENT
CAMERA
4 5 6 7
Card slot
1
AUDIO OUT L/R jacks
2
Loop through output of the audio line signal
input from the AUDIO IN jacks on the BRBK-H700
HD Optical Multiplex Card or BRBK-MF1 HD
Optical Multiplex Card inserted into the camera
via an optical fiber cable.
~ AC IN connector
3
CAMERA connector
4
EXT SYNC IN connector
5
EXT SYNC OUT connector
6
RGB/COMPONENT connector
7
Pin No. Signal Pin No.
1 Pr/R 9
2 Y/G 10
3 Pb/B 11
4 12
GND
5 GND 13
6 GND 14
7 GND 15
8
GND
VISCA RS-232C IN connector
8
Connect to the RM-BR300 Remote Control Unit.
When you join multiple cameras, connect it to
the VISCA RS-232C OUT connector of the previ-
ous camera in the daisy chain.
VISCA RS-232C OUT connector
9
When you join multiple cameras, connect it to
the VISCA RS-232C IN connector of the next
camera in the daisy chain.
VISCA RS-422 connector
10
2 3
AUDIO OUT
L
R
FUNCTION ~
AC IN
1 6
VISCA RS-422
IN VISCA RS-232C OUT
8 9 10 11
Signal
NC
GND
GND
NC
HD-OUT
Tri-level Sync/Bi-level VD
NC
VISCA FUNCTION switches
11
Switch 1
(RS-232C/RS-422 selector)
Set to ON for RS-422, or OFF for RS-232C.
Switch 2
(Communication baud rate selector)
Set to ON for 38400 bps, or OFF for 9600 bps.
Switches 3 to 5
(Camera address selectors)
Set the address of the camera. Normally set to
0. With this setting, addresses are assigned to
the cameras automatically in the connected
order by pressing the POWER button while
holding down the RESET button on the
RM-BR300 Remote Control Unit. You can assign
the camera address, 1 to 7, manually by setting
these selectors as follows:
Camera
0 1 2
address
Switch 3 OFF ON OFF
Switch 4 OFF OFF ON
Switch 5 OFF OFF OFF
Please note that the same camera address
Note
cannot be assigned to two or more different
cameras.
Switch 6
(59.94i/50i signal format selector)
Set to ON for output of 50i signal format, or OFF
for output of 59.94i signal format.
Please further note that you must set the switches
Note
before you turn on power to the multiplex unit.
3 4 5 6 7
ON OFF ON OFF ON
ON OFF OFF ON ON
OFF ON ON ON ON
23
Location and Function of Parts