Synchronization Methods - KoamTac KDC200 User Manual

Select from Current Running Application – This option allows you to select a currently running
application for data synchronization.
Note:
• Data synchronization begins immediately if Automatically After Connection is selected. If not
selected, data synchronization is started manually by the user.
• Users SHOULD NOT operate the PC during the synchronization process. It can interrupt the
process causing unreliable results.

Synchronization Methods

Fast Synchronization in Burst Mode
The KDC can synchronize data to a host device in Burst mode or Handshake mode. Burst mode
provides the fastest synchronization process but could result error in poor Bluetooth environment. Fast
synchronization in burst mode is only recommended with USB connection.
Synchronize Normal Data
The KDC will synchronize Normal Data only in KDC memory if Synchronize Normal Data option is
selected. If you want all data in KDC memory synchronized, you should select Synchronize Normal Data
and Synchronize Application Data.
Synchronize Application Data
The KDC will synchronize Application Data only in KDC memory if Synchronize Application Data option
is selected. If you want all data in KDC memory synchronized, you should select Synchronize Normal
Data and Synchronize Application Data.
Clear KDC Memory after Synchronization
The stored barcode data is cleared from the KDC memory after synchronization if this option is selected.
The KDC can store a total of 10,240 barcodes or 80KB of barcode data.
It is important to clear the KDC memory periodically to prevent Buffer Full message which will
prevent the KDC from storing additional data.
Stored barcode data can also be deleted using the Reset Memory feature on the KDC.
Automatically Synchronize after Connection
This option lets you automatically synchronize collected data to your computer immediately when the
44
KDC200 User Manual