Synchronization Methods - KoamTac KDC100 User Manual

Synchronization Methods

Fast Synchronization in Burst Mode
The KDC can synchronize data to a host device in Burst mode or Handshake mode. Burst mode provides
the fastest synchronization process when the Destination of Data option is set to File.
Clear KDC Memory after Synchronization
The stored barcode data is cleared from the KDC memory after synchronization if this option is selected. The
KDC can store a total of 10,240 barcodes or 200KB of barcode data.
It is important to clear the KDC memory periodically to prevent Buffer Full message which will prevent the
KDC from storing additional data.
Stored barcode data can also be deleted using the Reset Memory feature on the KDC.
Automatically Synchronize after Connection
This option lets you automatically synchronize collected data to your PC immediately when the KDC is
connected to the host.
IMPORTANT: Remember to configure all options properly before performing an automatic
synchronization process.
Data synchronization can be done manually by clicking the synchronize icon if this option is not selected.
Beep while Synchronization
You can enable or disable the beep tone during the synchronization process. A beep is sounded each and
every time barcode data is synchronized if this option is selected. The KDC beeps 5 times when the
synchronization process is complete.
31
KDC300 User Manual