Remove Monitor Stand For Mounting - Mitsubishi E55LCD Service Manual

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:
1. Place monitor face down on a non-abrasive surface (Place the screen on a 36 mm platform so that the stand is parallel
with the surface.) (Figure G.1).
2. Displace connector cover on the black of the monitor (Figure G.2).
3. To take off back cover, please follow the instructions of arrow while pressing two side of monitor (Figure G.3).
Next, lift up the stand, dismantle upper cover, then go on to dismantle the stand cover (Figure G.4).
Return the stand to its original position, remove the 4 screws that connect the monitor to the stand, and lift off the stand
assembly (Figure G.5).
4. Disconnect all cables.
5. Reverse this process to reattach stand.
NOTE: Use only VESA-compatible alternative mounting method.
Figure G.1
AC power cord
To power outlet To computer
Figure G.4
Caution: Please use the attached screws (4pcs) when mounting. To fulfil the safety requirements the monitor must be
mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The
LCD monitor shall only be used with an approved arm (e.g. GS mark).
PUSH
Figure G.2
1. Cable pass through
in this hole.
2. Connect each
connector.
Signal cable
Clip
English-4
1-9
PUSH
PUSH
Figure G.3
Figure G.5
PUSH