Installing Control Pcb And Clear Cover Sheet - Thermal Arc Fabricator 211i Service Manual

FABRICATOR 211i

7.04 Installing Control PCB and Clear Cover Sheet

Refer to diagram on page 7-5.
1. Install 4 screws.
2. Plug harness into DRIVE connector.
3. Plug harness into SOURCE connector.
4. Plug harness into CR connector.
5. Plug harness into FUNs connector.
6. Plug harness into m IGBT OT2 connector.
7. Plug harness into IGBT OT1 connector.
8. Plug harness into GUN connector.
9. Plug harness into QF/DY connector.
10. Plug harness into WVIN connector.
11. Plug harness into MB connector.
12. Plug harness into JC connector.
13. Plug harness into PWM connector.
14. Plug harness into IFB connector.
Verify harness connections with the system schematic to insure all connections are correct.
15. Install clear protective sheet.
ASSEMBLY PROCEDURES
ASSEMBLY PROCEDURES
7-4 Manual 0-5158