Installing Front Panel - Thermal Arc Fabricator 211i Service Manual

ASSEMBLY PROCEDURE

7.03 Installing Front Panel

1. Reinstall output Dinse on front panel with 27mm wrench.
Reconnect positive output terminal bolts and tighten with 17mm wrench. ( Note: reconnect wires, pay attention
to the wire colour.)
Reconnect negative output terminal bolts and tighten with 17mm wrench. (note: reconnect wires and pay at-
tention to the wire colour.)
2. Place display PCB and control panel assembly into front panel. Install screws.
3. Reconnect Front Panel screws.
Manual 0-5158
1
7-3
FABRICATOR 211i
2
3
Art # A-11354
ASSEMBLY PROCEDURES