Attaching The Tweco Fusion 220A Mig Gun - Thermal Arc Fabricator 211i Service Manual

FABRICATOR 211i INSTALLATION/SETUP

4.02 Attaching The TWECO Fusion 220A MIG Gun

Fit the Fusion MIG gun to the power source by pushing the MIG gun connector into the MIG gun adapter and screwing
the locking screw clockwise to secure the MIG gun to the MIG gun adapter.
Connect the 8 pin plug by aligning the keyway then inserting the 8 pin plug into the 8 pin socket and rotate threaded
collar fully clockwise to lock the plug into position.
MIG Gun Adapter
MIG Gun Connector
8 pin socket
8 pin plug
Locking Screw
Wire Drive Tension Knob
Pressure Arm
MIG Gun Connector
Inlet Guide
Art # A-11242_AB
Outlet Guide
Figure 4-5: Attaching MIG Gun
INSTALLATION/SETUP 4-8 Manual 0-5158