Setup For Operation; Arc Control - Thermal Arc 260S CC STICK Operating Instructions Manual

3.02 Setup for Operation

Arc Control

SETUP FOR OPERATION
The ARC CONTROL provides a suitable short circuit amperage to suit
individual welding situations when operating in the STICK welding
(SMAW) mode.
The Arc Control current is set to 45 Amperes (30%) in factory. If you want
to change Arc Control current, it will be necessary to change dip switch [9]
(DSW1) on the front panel PC Board (PCB7 [WK-4224 ] ).
The Dip Switch setting for the Arc Control current is classified as follows.
Dip Switch
1 2 3
ON OFF OFF OFF
OFF ON OFF OFF
OFF OFF ON
OFF OFF OFF
* Do not set other combinations.
24
F r o n t
Arc Control
4 Amperes Percentage
15A
30A
OFF 45A
ON 60A
Factory
Shipping
10% -
20% -
30%
40% -
MANUAL 430429-447