Cleaning And Maintenance - Kärcher KM 100 R B Operating Instructions Manual

Operating instructions
Fastening areas
Note:
Observe markings for fastening
areas on base frame! (chain
symbols)
For loading or unloading the
machine may be operated on slopes
of only up to a max. of 18 %

Cleaning and maintenance

! Stand sweeper on a flat surface
! Turn ignition key to "0" and
remove it
Internal cleaning
Danger!
Wear dust mask!
Wear safety goggles!
! Open unit cover, engage stay bar
! Clean with a rag
! Blow-out with compressed air
KM 100/100 R B / KM 100/100 R LPG
External cleaning
Clean with a damp cloth previously
soaked in mild suds
Note:
Do not use any aggressive cleaning
agents!
Maintenance intervals
Elapsed-time meter
Elapsed-time meter indicates
maintenance interval times.
Maintenance by the
customer
Daily maintenance
(KM 100/100 R B) or whenever the
gas cylinder is replaced
(KM 100/100 R LPG)
! Check the engine oil level
! Check axle drive oil level
! Check the tyre air pressure
! Check gas hoses and threaded
line joints. (applies only to
KM 100/100 R LPG)
! Check the gas filter in the
screwed connection to the gas
cylinder for dirt accumulation,
clean it, if necessary (during
every gas cylinder replacement).
(applies only to
KM 100/100 R LPG)
! Check the function of all
operating controls
Maintenance weekly
! Check petrol or gas lines for
leakages
! Check air filter
! Check oil level of sweeping
hydraulics
! Check hydraulic hose for leaks
! Check freedom of movement of
Bowden cables and moving parts
! Check setting and wear of
sealing strips in sweeping area
! Check vacuum system (operation
of lowering side brushes)
Maintenance every 100 operating
hours
! Check petrol or gas lines for
leakages
! Enging-oil change (first change
after 20 operating hours)
! Check the spark plug
! Check operation of seat contact
switch
! Checking the battery acid level
! Check tightness, wear and
operation of drive belts (V-belts
and round belts)
Maintenance according to degree
of wear
! Replace sealing strips
! Replacing the sweep roller
! Replacing the side broom
See maintenance tasks chapter for
description
Note:
Where maintenance is undertaken
by the customer, all service and
maintenance work must be carried
out by a qualified employee.
A Kärcher specialist dealer can be
consulted whenever support is
necessary.
Maintenance by the
customer service
department
Maintenance after 20 operating
hours
First inspection
Maintenance every 100 operating
hours
Maintenance every 300 operating
hours
Note:
To safeguard warranty rights, during
the warranty period all service and
maintenance work must be
performed by an authorised Kärcher
after sales service.
English
Maintenance tasks
Notes on safety
Warning!
Preparations
! Stand sweeper on a flat surface
! Turn ignition key to "0" and
remove it
Danger!
— The engine takes approx. 3...4 s
to run down after being shut off.
! Never enter operating area
during this period!
! Allow the machine to adequately
cool down prior to all
maintenance and repair work
! Do not touch hot parts such as
the driving engine and exhaust
system.
Caution, environment is
endangered by engine oil!
! Take spent oil after an oil change
to an oil collecting point or a
waste disposal company.
33