Controls; Maintenance; Pad Installation - Kärcher LB2000I Operating Instructions Manual

Operations

Controls

1. Safety Lock – Prevents unintended operation of
the machine.
2. Switch Levers – Turns machine on/off.
2
Operations
For indoor use only.
Pour utilisation à l'intérieur seulement.
When using the pad, always keep the machine
moving when in contact with the floor.
Couple de démarrage élevé. Tenez la machine
fermement à deux mains.
High starting torque. Hold machine firmly with
both hands.
Couple de démarrage élevé. Tenez la machine
fermement à deux mains.
1. Ensure that the pad driver is in good shape.
Install or change pad if necessary.
14
1
2
86402450 Operators Manual - High Speed Burnisher (2000 Series)
2. Plug the machine into a wall outlet as described
in the grounding instructions.
3. Release latch, lower the handle and move into
position.
4. Push the safety lock forward, unlocking the
switch levers.
5. With the safety lock forward, squeeze one or
both of the switch levers, turning the machine on.
(These levers can be operated independently of
each other). The safety lock will not re-engage
until both levers are released.
6. To stop the machine, release the switch levers.
7. Do not let machine rest on pad. When finished
with the machine, return handle to the storage
position.
NOTE: The machine is equipped with a circuit
breaker to protect the motor in the event an
overload condition occurs. The circuit breaker is
located on the handle. Push the reset button to
restart the machine. If the breaker trips again,
correct the cause of overloading before proceeding.

Maintenance

1. Inspect power cord for wear. To prevent electrical
shock replace cords with frayed or cracked insu-
lation immediately.
2. Place machine in the storage position.
3. Check pad condition. Change if soiled or torn.

Pad Installation

1. Lay machine back, exposing the under side.
2. Remove center lock by turning counter-clock-
wise.
3. Ensure pad is centered on pad driver. Pull pad to
edge of pad driver in several directions to check
for proper engagement.
4. Replace center lock by turning clockwise firmly
compressing the center of the pad.
HANDLE
RELEASE
LATCH