Extreme Flight 78" EXTRA 300 ARF Instruction Manual page 23

Radio control state-of-the-art r/c aerobatic aircraft and accessories

Hide thumbs Also See for 78" EXTRA 300 ARF:

Table of Contents

26. Remove the covering over the holes in each side of the rear of the fuselage for the

elevator servos. Attach a 36" extension to the servo lead and install the servos with the

output shafts toward the rear of the fuselage using the manufacturer supplied mounting

hardware. Slide both stab/elevator assemblies onto the carbon fiber mounting tube and

secure with 2 3mm bolts inserted through a washer and the mounting tabs and into the

corresponding blind nuts already installed in the fuselage. Thread a ball link on each end

of a titanium pushrod and secure to the servo arm and elevator control horns with a 3mm

bolt and nylon insert locknut. Again we recommend the SWB 1.5 inch servo arm for

elevator actuation. Be sure to use a drop of blue Loctite on all bolts!!!

Table of Contents

Show Quick Links

Table of Contents