Extreme Flight 78" EXTRA 300 ARF Instruction Manual page 13

9. Before beginning the next assembly process, take a few minutes with your sealing iron
on a medium heat setting and go over all seams, paying special attention to thin trim
stripes and the seam at the leading edge of the wing. If there are wrinkles in the covering
on the leading edge sheeting use a heat gun with a 100% cotton t-shirt to remove them and
prevent digging into the wood with an iron. Use caution and avoid excessive heat as you
may cause the Ultracote to shrink too much and lift at the seams. Also take the time to seal
the hinge gaps with Ultracote or Blenderm tape. Clean the wings with Windex and put
them away.
13