Oem Rack - IBM Power 750 Technical Overview And Introduction

1.13.7 OEM rack

The system can be installed in a suitable OEM rack, if the rack conforms to the EIA-310-D
standard for 19-inch racks. This standard is published by the Electrical Industries Alliance. For
detailed information see the IBM Power Systems Hardware Information Center:
http://publib.boulder.ibm.com/infocenter/systems/scope/hw/index.jsp
The key points mentioned are as follows:
The front rack opening must be 451 mm wide ± 0.75 mm (17.75 in. ± 0.03 in.), and the
rail-mounting holes must be 465 mm ± 0.8 mm (18.3 in. ± 0.03 in.) apart on center
(horizontal width between the vertical columns of holes on the two front-mounting flanges
and on the two rear-mounting flanges). Figure 1-13 shows a top view showing the
specification dimensions.
Figure 1-13 Top view of non-IBM rack specification dimensions
40
IBM Power 750 and 760 Technical Overview and Introduction
Drawer Rail
Mounting
Flanges
571mm (22.50 in.)
Back, No Door
494mm (19.45 in.)
Front, No Door
451mm (17.76 in.)
494mm (19.45 in.)
203mm (8.0 in.)
719mm (28.31 in.)
51mm (2.01 in.)