Leveling Bolts & Metal Shims; Door Handle Assembly; Door Latch Adjustment - Quadra-Fire 4100I-GD-B User Manual

4100-I ACT Wood Insert
Leveling Bolts And Sheet Metal Shims
This product shipped with two leveling bolts, and two sheet
metal guides for ease in sliding the insert into place when
using the leveling bolts. Not all installations will require the
use of the leveling bolts. The sheet metal guides are used
only when the leveling bolts are necessary. Discard if not
needed.
Sheet Metal Guides
Slide each guide under the insert on each side placing
them directly under leveling bolts. If they are not directly
under the bolts, the bolts may hang up on uneven material
when sliding the insert into place. Figure 16.1.
Sheet Metal Shims
Place under leveling bolts
and slide insert into place
Figure 16.1
Adjusting The Leveling Bolts
It is best to use a 1/2 inch (12.7mm) socket wrench with an
extended handle for ease in adjusting bolts to the desired
level. The bolts will adjust from 0 to 2 inches (0 - 51mm).
You can also reach in and adjust the bolts by hand, although
space is limited. Figure 16.2.
Reach between side of insert and outer skin
Figure 16.2
Page 16
Leveling Bolts
cut-out view
Leveling Bolt

Door Handle Assembly

Washer
Nut 1/4-20
Door Latch Bracket
Figure 16.3

Door Latch Adjustment

It is important the door gasket has a proper seal. As the
gasket compresses or "seats" during use, it may become
necessary to adjust or tighten the door latch.
1. Loosen securing screw (do not remove).
2. Turn adjustment bolts as need for adjustment (in or out)
using 7/16" end wrench.
. Tighten securing screw to hold adjusted position in
place.
Figure 16.4
250-7201F
Hook Door Latch
Door Handle
Washer, 5/8 x 1/4
Fiber Handle
Securing
Screw
Adjustment Bolts
April 19, 2010
R