Panel & Trim Set Installation - Quadra-Fire 4100I-GD-B User Manual

4100-I ACT Wood Insert
Panel Set And Cast Trim Set
Standard Size: 30-1/2" h x 44-3/4"w
Large Size: 34"h x 48"w
NOTE: panel and cast Trim must be
ordered separately.
Included in Panel Kit: (2) side panels, left and right; (1)
panel top; (2) trim pieces; (1) trim top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right;
(1) cast trim header; (2) cast trim footers, left and right.
Tools Needed: Powered Phillips head screwdriver
1. Remove contents from box being careful not to scratch
or damage cast trim pieces.
2. Lay the panel set face down on protective covering to
prevent scratching the painted surface.
. Secure panel set together with screws provided.
Figure 18.1.
2. Bend tabs
Figure 18.1
Panel And Gold Trim Set
Basic Standard Size: 30"h x 40"w
Tab with screw
hole to secure
panel to insert
Figure 18.3
Page 18
1. Screw side panels
Tab with screw hole to
secure panel to insert
. Install Cast Trim
Header
Screw side
panels to top
panel
4. Now bend the tabs down toward the backside of the panel
set, on top piece and on each leg. Leave panel set face
down.
5. Place the corresponding cast trim pieces (2 cast trim legs
and 1 cast trim header) underneath panel set, also face
down.
6. Place washer provided over tab and secure the trim and
panel together with screw. Continue for all tabs.
7. Secure cast footers with screws.
CAUTION: DO NOT PICK UP ASSEMBLED UNIT BY
CORNERS. IT IS TOO HEAVY AND MAY DAMAGE THE
PANELS. PICK UP FROM CENTER.
8. Slide assembled panel and trim over top of the insert
into place.
9. Secure panels to insert with 8-2 sheet metal screws
through tabs on bottom lower inside corners on side
panels. Figure 18.2.
to top panel
2. Bend tabs
Secure side panels to insert with screws
Figure 18.2
1. Repeat Steps 1 -  above.
2. To assemble the trim, attach the 2 side trim pieces
to the top trim at each corner using the "L" bracket
included in fasteners package. Figure 18.3
. Slide panel and trim over top of the insert and into
position.
Figure 18.4
250-7201F
-
Completed view
View of "L" Bracket
installed
April 19, 2010
R