Installing Outer Can & Leveling Bolts; Surround & Trim Kit Installation - Quadra-Fire 31-I ACC Installation Manual

31-I ACC
E. Installing Outer Can & Leveling Bolts
1. Align the back of surface of outer can side panels to the
front wall surface for proper placement. Figure 20.2.
Use the leveling bolts to level the outer can. Figure 20.1.
3. Thread the horizontal support bolts in until they hit the
back wall of the fi replace to help secure in place. Figure
20.3.
4. It is recommended that you use the pallet mounting holes
to lag the outer can into the fi replace fl oor for extra sup-
port, however it is not required.
Outer Can Side Panels
Wall
Support Bolts
Leveling Bolts
Figure 20.1
Wall
Outer Can
Side Panel
Figure 20.2
Back Wall
Horizontal Support
Bolts
Figure 20.3
20
Wall
Horizontal
F. Surround & Trim Kit Installation
1. Lay surround face down on a protected surface to pre-
vent scratching.
2. Using a Phillips head screw driver attach the side sur-
rounds to the top surround using 2 #8 sheet metal screws
provided with the kit. Figure 20.4.
3. Lay the trim face down and place the corner brackets into
position.
4. Using a standard fl at screw driver tighten the corner
brackets. Figure 20.5.
5. Slide the trim over the surround set.
6. Install the surround set and trim set to the outer can.
Secure the top and side surrounds as shown in Figure
20.6.
Attachment Holes to Outer Can
Figure 20.4
Figure 20.5
Side Surround
Figure 20.6
7044-225D
Secure 2 Side Surrounds to
Top Surround
Top Surround
# 8 Screws
August 3, 2015