Installing Outer Can & Leveling Bolts; Surround & Trim Installation - Quadra-Fire 31I-ACC Owner's Manual

3100-I ACC Wood Insert
E. Installing Outer Can & Leveling Bolts
1. Align the back of surface of outer can side panels to the
front wall surface for proper placement. Figure 40.2.
Use the leveling bolts to level the outer can. Figure 40.1.
3. Thread the horizontal support bolts in until they hit the
back wall of the fi replace to help secure in place. Figure
40.3.
4. It is recommended that you use the pallet mounting holes
to lag the outer can into the fi replace fl oor for extra sup-
port, however it is not required.
Outer Can Side Panels
Wall
Support Bolts
Leveling Bolts
Figure 40.1
Wall
Outer Can
Side Panel
Figure 40.2
Back Wall
Horizontal Support
Bolts
Figure 40.3
Page 40
Wall
Horizontal
F. Surround & Trim Kit Installation
1. Lay surround face down on a protected surface to pre-
vent scratching.
2. Using a Phillips head screw driver attach the side sur-
rounds to the top surround using 2 #8 sheet metal screws
provided with the kit. Figure 40.4.
3. Lay the trim face down and place the corner brackets into
position.
4. Using a standard fl at screw driver tighten the corner
brackets. Figure 40.5.
5. Slide the trim over the surround set.
6. Install the surround set and trim set to the outer can.
Secure the top and side surrounds as shown in Figure
40.6
Secure 2 Side Surrounds to
Attachment Holes to Outer Can
Figure 40.4
Figure 40.5
7044-140C
Top Surround
Corner Brackets
Top Surround
Side Surround
# 8 Screws
Figure 40.6
November 21, 2011
R