Using The Digital Operator; Nomenclature - Omron SYSDRIVE 3G3HV SERIES User Manual

Preparing for Operation
3-2

Using the Digital Operator

3-2-1 Nomenclature

Easy-setting indicators
Displays basic parameter
constants and monitor items.
(See note 1.)
Mode Key
Switches basic parameter
constant and monitor items.
Operation Mode Selection Key
Switches between operation by the
Digital Operator and operation
specified in the operation mode
selection parameter (n002).
Run Key
Starts the Inverter.
Note 1. The Inverter does not start while any indicator on the bottom two lines is lit. To start the Invert-
er, press the Mode Key to light up an indicator on the top two lines and press the RUN Key.
Note 2. For safety reasons, the reset function cannot be used while the run command (forward/re-
verse) is being input. Turn the run command OFF before using the reset function.
3-4
REMOTE
SEQ REF
Fref Fout Iout kWout
F/R Montr Accel Decel
Vmtr V/F Fgain Fbias
FLA PID kWsav PRGM
DIGITAL OPERATOR PJVOP131E
LOCAL
REMOTE
STOP
RUN
RESET
Chapter 3
Operation Mode Indicators
External Operation:
Lit when operating references from exter-
nal terminals are in effect.
Analog Input:
Lit when high-frequency references from
external analog terminals are in effect.
Data Display
Displays frequency reference, out-
put frequency, output current,
constant set values, Inverter status,
etc.
Enter Key
Enters set value when pressed after
constant has been set.
Increment Key
Increments numbers when pressed
during setting of constant number
and constant data.
Decrement Key
Decrements numbers when
pressed during setting of constant
number and constant data.
Stop/Reset Key
Stops the Inverter. Also resets after
alarm has been generated. (See note 2.)