Framing Requirements - Valor 1700IN Installation & Owner's Manual

QUALIFIED
INSTALLER
Framing Dimensions
Minimum Cement Board Dimensions
Non-combustible
cement board
required
thickness:
1/2 inch (13 mm)
NON-COMBUSTIBLE MATERIALS ONLY
READ INSTRUCTIONS
MATÉRIAUX INCOMBUSTIBLES SEULEMENT
CONSULTEZ LE GUIDE D'INSTALLATION
SCREWS ALLOWED IN THIS AREA
VIS PERMISES DANS CET ESPACE
MAXIMUM RECOMMENDED SCREW LENGTH
LONGUEUR DE VIS CONSEILLÉE :
MAXIMUM 1-1/4" (32 mm)
24

Framing Requirements

1/2" thick non-combustible
cement board required above,
on each side and below
engine opening (NOT supplied)
NOTE: This unit requires a
solid platform to support it.
Combustible framing allowed
beneath fireplace. When the
appliance is installed directly
on carpeting, tile or other
combustible material other
than wood flooring, the
appliance shall be installed
on a metal or wood panel
extending the full width
and recessed depth of the
appliance
Minimum coverage area of non-combustible cement board.
Any wall finish applied to shaded area must be non-combustible.
Min. 5"
(127 mm)
NOTE: Height of cavity may be
affected by vent configuration
- see page 26
Min. 60" (1524 mm)
50" (1270 mm)
NON-COMBUSTIBLE MATERIALS ONLY NON-COMBUSTIBLE MATERIALS ONLY
READ INSTRUCTIONS READ I READ INSTRUC NSTRUCTIONS TIONS
MATÉRIAUX INCOMBUSTIBLES SEULEMENT MATÉRI MATÉRIAUX IN AUX INCOMBUS COMBUSTIBLES TIBLES SEULE SEULEMENT MENT
CONSULTEZ LE GUIDE D'INSTALLATION CONSUL CONSULTEZ LE TEZ LE GUIDE GUIDE D'INS D'INSTALLAT TALLATION ION
SCREWS ALLOW SCREWS SCREWS ALLOWED IN THIS AREA ALLOWED IN ED IN THIS A THIS AREA REA
VIS PE VIS PERMISES DANS CET ESPACE VIS PERMISES RMISES DANS DANS CET ES CET ESPACE PACE
MAXIMUM RECOMMENDED SCREW LENGTH MAXIMUM RECOMMENDED SCREW LENGTH
LONGUEUR LONGUEUR DE VIS CONSEILLÉE : MAXIMUM ONGUEU DE VIS CO D NSEILLÉE : MAXIMUM
1-1/4" (32 mm) 1-1/4" (3 1-1/4" / " ( / " ( (32 mm) 2 mm) ) )
Between underside
of header and bottom
of firebox
43"
No hearth required.
If using a hearth,
see page 22.
Min. 5"
(127 mm)
Linear 1700 fireplace outline
(including stand-offs)
Joints preferred at corners
to prevent cracking
Flush with bottom of unit;
add extra cement board
if overlapping framing.