Valor 1700IN Installation & Owner's Manual page 46

QUALIFIED
INSTALLER
2. Install the sheet metal platform on top of the
brackets as indicated. The edge of the burner
protrudes above the platform. Push the platform as
far back as possible to maximize the air gap behind
the burner.
Top view—platform
Installed platform
3. Install the glass plates on the platform, the textured
side underneath and the smooth side on top. Follow
the diagram below as the pieces are not all the
same size. Ensure each piece is up against an end
stop.
end stops
platform
glass plates
pilot area narrower glass plates at the back
longer glass plates
narrower
in the middle
wider glass plates at the front
Top view—glass plates
Installed glass plates
46
Murano Glass Fire Installation
Gap behind burner
No gap in front of burner
wider
4. Mix the black and blue fi re glass together.
5. Fill a small container with approximately 3 cups
(750 ml) of mixed fi re glass.
6. Carefully spread the fi reglass on the surface of
burner patting it gently with your hand to form a
single layer to the approximate level of the top edge
of the fl ange around the burner. Do not pour too
much to avoid blocking the burner ports.
7. Some fi reglass may be added on the platform to
cover the edge of the burner and in the space in
front and behind the pilot shield.
NOTE: Ensure the area within the pilot shield is
clear of fi reglass.
Pilot shield
WARNING
!
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi re glass particles as these could
be ingested by small children. Vacuum area after
installation.