Valor 1700IN Installation & Owner's Manual page 7

WARNING
!
CHOKING HAZARD! Ensure that the fi replace
area is clear of fi re glass or vermiculite particles as
these could be ingested by small children. Vacuum
thoroughly around the fi replace area after cleaning.
To refi t the window:
1. Place it in its bottom railing and push its top against
the fi rebox.
2. While you hold it, pull the side levers back into the
window brackets on each side.
IMPORTANT: To ensure a safe operation, verify
that the levers are hooked properly to the window
tabs; then, pull out the top of the window and
release it to insure the springs return it.
3. Apply light hand pressure against the window frame
sides to bed-in the window seal.
4. If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Hot Glass Warning Plate
5. Reinstall the barrier screen on the trim.
a) 1755 1" trim: Insert the screen's top tabs in the
slots in the convection baffl e then rest the screen
bottom tabs on the edge of the opening in the
plinth to lock it in position.
b) 1750 5.1/4" trim: Hook the bottom of the screen
to the bottom edge of the trim's front plate, then,
with the top levers up, push the screen against
the fi replace. Rotate the levers down to hook
them up to the trim and slide them inwards to
secure them.
6. Verify that the screen is properly hooked to the trim
and secure.
WARNING
!
FOR SAFETY PURPOSE, ensure the barrier FOR SAFETY PURPOSE, ensure the barrier
screen is re-installed on the fi replace front screen is re-installed on the fi replace front
after maintenance. after maintenance.
Owner's Information
Checks
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Pilot Flame can be seen
between the front and
rear left logs
Long Beach Driftwood Kit Correct Flame Picture
Pilot Flame can
be seen left of
the fi re bed
Murano Glass Fire Correct Flame Picture
Pilot Flame
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Remote Control Handset Wall
Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further
on in this manual for the installation.
OWNER'S
INFORMATION
Thermocouple Probe
must be in Flame
7