Valor 1700IN Installation & Owner's Manual page 41

The ceramic liners install in the manner outline below.
For the enamel liners, an infi ll set will be needed
with less than 3'-0" vertical pipe rise in vent sys-
tem—see the installation instructions supplied with
the liners. Unpack the liner panels carefully.
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors (one per side)
just enough to allow them to rotate.
2. Place the right end panel against the right wall of
the fi rebox.
3. The rear panel is supplied in three sections which
are fi tted into each other. Two of the sections are
identical. Their step edges go towards the middle to
fi t into the middle section.
Rear panel sections—top view
Liners Installation
Place the panel's right section on the ledge above
the ports of the rear of the fi rebox. The section sits
on the ledge behind the tabs, with its plain edge on
right side; slide it behind the right side panel.
4. The top panel is supplied in
two identical sections. The top
of the panel is beveled and the
'fi re side' is straight at the front
and notched at the back. When
installed, the panel rests on the
top of the rear and side panels. In
the front, it rests on the top panel
support bracket located inside the
front edge of the fi rebox.
Position and slide top panel into corner.
Top panel
support
bracket
5. Carefully position, lift and slide second section of the
top panel on top of the fi rst.
QUALIFIED
INSTALLER
top
underside
(fi re side)
rear
panel
41