Framing Requirements - Valor 1500IN (NG) Installation & Owner's Manual

Framing Dimensions
Minimum Cement Board Dimensions
Non-combustible
cement board
required
thickness:
1/2 inch (13 mm)
NON-COMBUSTIBLE MATERIALS ONLY
READ INSTRUCTIONS
MATÉRIAUX INCOMBUSTIBLES SEULEMENT
CONSULTEZ LE GUIDE D'INSTALLATION

Framing Requirements

1/2" thick non-combustible
cement board required above,
on each side and below
engine opening (NOT supplied)
NOTE: This unit requires a
solid platform to support it.
Combustible framing allowed
beneath fireplace. When the
appliance is installed directly
on carpeting, tile or other
combustible material other
than wood flooring, the
appliance shall be installed
on a metal or wood panel
extending the full width
and recessed depth of the
appliance
Minimum coverage area of non-combustible cement board.
Any wall finish applied to shaded area must be non-combustible.
Min. 4"
(102 mm)
NOTE: Height of cavity may be
affected by vent configuration
27.
- see page 26
Min. 48" (1219 mm)
40" (1016 mm)
NON-COMBUSTIBLE MATERIALS ONLY NON-COMBUSTIBLE MATERIALS ONLY
READ READ I READ INSTRUCTIONS INSTRUC NSTRUCTIONS TIONS
MATÉRIAUX IN MATÉRI MATÉRIAUX INCOMBUSTIBLES SEULEMENT AUX INCOMBUS COMBUSTIBLES TIBLES SEULE SEULEMENT MENT
CONSULTEZ LE GUIDE D'INSTALLATION CONSULTEZ LE CONSUL TEZ LE GUIDE GUIDE D'INS D'INSTALLAT TALLATION ION
QUALIFIED
INSTALLER
Between underside
of header and bottom
of firebox
43"
No hearth required.
If using a hearth,
23.
see page 22.
Min. 4"
(102 mm)
Linear 1500 fireplace outline
(including stand-offs)
Flush with bottom of unit;
add extra cement board
if overlapping framing.
25