Installation; Receiving And Uncrating; Installing The Legs; Clearances - Lang DO36 Installation & Operation Manual

RECEIVING AND UNCRATING

Upon receipt of the equipment, check for
freight damage, both concealed and
visible. Visible damage must be noted on
the freight bill at the time of delivery and
signed for by the freight company's agent.
Concealed loss or damage means loss or
damage which does not become apparent
until the merchandise has been unpacked.
When concealed damage is discovered,
make a written request for inspection by
the carrier's agent within 15 days of the
delivery date. In either case, do not
return the damaged merchandise to
Star Manufacturing, file your claim with
the carrier.
Before uncrating the equipment confirm
that the voltage marked on the box
matches that of the building. The oven
voltage must match the voltage supplied.
Place the crate as near the intended
installation as possible before uncrating
the equipment. The crate will help protect
the equipment while it is being moved
through doorways
Uncrate the oven and set as near the
intended installation as practical.
the crating materials as they may be used
during the installation.

INSTALLING THE LEGS

If the oven is to be assembled as a range
the legs are packaged in with the range
top. If the oven is to be stacked on
another oven the legs are packaged in a
separate box marked "Fabricated Legs".
Place some cardboard on the floor and
gently tip the oven backwards onto it.
The range legs are screwed into 4 nuts
welded to the bottom of the oven. Make
and down halls.
Save
sure the legs are screwed firmly into the
nuts.
The stacked oven fabricated legs attach to
the bottom corners of the oven with the
nuts and bolts supplied with the legs.
Set the oven on the legs, push it into
position, and level it using the adjusters
on the bottom of the legs.

CLEARANCES

THE FOLLOWING CLEARANCES TO
COMBUSTIBLE SURFACES MUST BE
MAINTAINED:
4 INCHES TO SIDES
3 INCHES TO BACK

DECK OVEN ASSEMBLY

STACKING THE OVENS

If the oven is to be assembled as a range,
skip this section refer to the Range Top
Installation Manual.
Remove the envelope labeled "Stacking
Kit" from the oven cavity.
Place some cardboard on the floor and
gently tip the oven that is to be stacked
backwards onto it. Install four pins from
the stacking kit into the threaded holes on
the side flanges of the oven bottom.
Remove the plastic plugs from the top of
the oven on legs so the pins just installed
in the top oven can nest into the holes.
Lift the oven that is lying on its back onto
the oven on legs. Align the pins so they
drop into the holes in the bottom oven.
3

INSTALLATION