Range Assembly; Installation On Oven Base; Electrical Connection - Lang DO36 Installation & Operation Manual

RANGE ASSEMBLY

INSTALLATION ON OVEN BASE

Remove all the plastic plug buttons from
the top of oven(s).
Lay a 2 X 4 or cardboard corner pad
across the top of the oven.
Lift the range top off of the shipping skid
and place it on top of the oven so that the
front edge of the range top is sitting on the
2 X 4 and is elevated off of the oven top.
Feed the two groups of power supply
wires through the two holes in the oven
top until all the wire slack is inside the
oven control compartment.
Lift the front of the range top and remove
the 2 X 4.
Allow the range top to set into place so
that the pins in the bottom if the range top
nest into the holes in the top of the oven
base.

ELECTRICAL CONNECTION

The electrical connection must be made in
accordance with local codes or in the
absence of local codes with NFPA No. 70
latest edition (in Canada use: CSA STD.
C22.1)
Supply wire size must be large enough to
carry the amperage load for the range
being installed. Wire size information can
be found on the range data plate.
This range can be installed on both single
and three phase supplies and is shipped
from the factory un-phased.
The range top wires connect into a
terminal block located in the oven base
control compartment.
6