Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Lang DO36
Summary of Contents for Lang DO36
- Page 1 Installation, Operation, and Maintenance Instructions Deck Oven Model: DO36 and DO36L Star Manufacturing International 10 Sunnen Drive St. Louis, MO.63143-3800 Part Number: 2M-W475 Ph: 314-678-6315 Fax: 314-781-2714 www.langworld.com Rev.A November 2, 2007...
-
Page 2: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS ......................1 INTRODUCTION DESCRIPTION........................1 FEATURES ........................1 SAFETY PRECAUTIONS AND WARNINGS................2 INSTALLATION RECEIVING AND UNCRATING ..................3 INSTALLING THE LEGS ....................3 CLEARANCES....................3 DECK OVEN ASSEMBLY ....................3 STACKING THE OVENS...................3 ELECTRICAL CONNECTION................4 INTERCONNECTING THE OVENS ..............4 OVEN PHASING....................5 LOAD REQUIREMENTS ...................5 RANGE ASSEMBLY .......................6 INSTALLATION ON OVEN BASE ..............6... -
Page 3: Introduction
INTRODUCTION This manual contains the necessary information to install, operate, and maintain the Lang DO36L Series Electric Deck Oven. DESCRIPTION The DO36 Series Deck Oven is designed They are controlled by a thermostat with as a single pan all purpose baking and an operational range of 150°F to 550°F... -
Page 4: Safety Precautions And Warnings
SAFETY PRECAUTIONS AND WARNINGS DANGER MAKE SURE THE MAIN POWER SUPPLY IS TURNED OFF AT THE SOURCE PRIOR TO CONNECTING POWER TO THE APPLIANCE. Disconnect the appliance from power before attempting any repair The following clearances to combustible surfaces must be maintained. 4 inches to sides 3 inches to back Make sure the wire leads that supply electricity to the cook top or upper oven decks are not... -
Page 5: Installation
INSTALLATION RECEIVING AND UNCRATING Upon receipt of the equipment, check for sure the legs are screwed firmly into the freight damage, both concealed and nuts. visible. Visible damage must be noted on The stacked oven fabricated legs attach to the freight bill at the time of delivery and the bottom corners of the oven with the signed for by the freight company's agent. -
Page 6: Electrical Connection
ELECTRICAL CONNECTION DANGER MAKE SURE THE POWER SUPPLY TO THE APPLIANCE IS TURNED OFF BEFORE MAKING THE CONNECTION. If the oven is to be assembled as a range, skip this section and refer to the Range Top Installation Manual. The electrical connection is made through Strip the cut ends of the wires 3/4 inch a 1 1/4 inch knockout in the bottom of the and install them into the terminal block of... -
Page 7: Oven Phasing
OVEN PHASING OVEN Power Terminal Supply Block Deck Deck Deck Single Phase Three Phase LOAD REQUIREMENTS LOADING THREE PHASE AMPS SINGLE MODEL TOTA PHASE AMPS 208 VOLT 240 VOLT 480 VOLT KW PER PHASE L Kw LI L2 L2 L3 L3 L1 208V 240V... -
Page 8: Range Assembly
RANGE ASSEMBLY ELECTRICAL CONNECTION INSTALLATION ON OVEN BASE The electrical connection must be made in Remove all the plastic plug buttons from accordance with local codes or in the the top of oven(s). absence of local codes with NFPA No. 70 Lay a 2 X 4 or cardboard corner pad latest edition (in Canada use: CSA STD. -
Page 9: Phasing Range Assembly
Follow the drawings, below, to group the supply wires to match the power phase. THREE PHASE SINGLE PHASE LOAD REQUIREMENTS For proper supply wire and circuit breaker size, refer to the chart below. THREE PHASE LOADING NOMINAL AMPS PER LINE Star Lang Total SINGLE THREE PHASE Model Model PHASE K.W. PER PHASE... -
Page 10: Operation
OPERATION INITIAL START-UP The preservatives must be cleaned off the NORMAL OPERATION oven front before it is heated. Wipe the oven front with a damp rag and a mild PREHEATING soap solution, rinse with warm water and The oven will not bake uniformly if not a damp rag, and then completely dry the allowed to thoroughly preheat before oven front. -
Page 11: Control Panel
CONTROL PANEL 3-HEAT SWITCHES product. Best results for baking will be While the oven thermostat controls the accomplished with the top 3-Heat switch set to temperature, the 3-Heat switches control the the "Low" position and the bottom 3-Heat amount of power from the upper and lower switch set to either "Medium"... -
Page 12: Pan Placement
PAN PLACEMENT Place the pan in the center of the oven products require moist baking rack for the best baking results. Keep the environment push vent damper oven door closed as much as possible. closed. Excessively opening the oven door will cool the front section of the oven and the TIMER products placed near the opening will... -
Page 13: Productive Maintenance
PRODUCTIVE MAINTENANCE "Productive Maintenance" is defined as a means of keeping the appliance as efficient and productive after years of service as it was when new. CLEANING Cleaning the appliance on a regular basis will assure years of efficient performance and maintain the gleaming appearance it has when new. -
Page 14: Calibration Adjustment
CALIBRATION ADJUSTMENT A 1/16 inch flat blade screwdriver with a 2 inch shaft is required to adjust the thermostat. Maintain the oven temperature at 350°F degrees. Without turning the thermostat dial, pull it off the shaft of the thermostat. Locate the screw at the base of the thermostat shaft; this is the thermostat calibration screw. Insert a small flat blade screwdriver down the thermostat shaft until it contacts the screw. -
Page 15: Installation Troubleshooting Guide
INSTALLATION TROUBLE SHOOTING GUIDE SYMPTOM PROBLEM CAUSE Breakers off Reset Breakers Not Heating Not Connected to Power Connect to Power Improper Phasing at Terminal Correct Phasing Block Defective Thermostat Replace Thermostat One Deck Works Others Do Internal Circuit Breakers off Reset Breakers Ovens Not Interconnected Improper Phasing at Terminal... - Page 18 See Detail See Detail Model: DO36 Deck Oven LA36 Deck Oven SK2423 Rev. - 6/08/09...
-
Page 19: Parts List
PARTS LIST October 4, 2012, Rev A Model: DO36 BAKE DECK OVEN Fig No Part No Description Application 2C-20103-02 SCRW SM PLT 10 X .5 PHLSL N9-LA36-159 DO36L (LOWER STACKED UNITS) TOP LA OVEN S/S N9-LA36-159-1 DO36 2N-11050-25 ELE 36OVN 240V O/S 1.8KW DO36-240VM 2N-11050-29 ELMNT 36”... - Page 20 Detail Detail Model: DO36 Deck Oven, Details A & B LA36 Deck Oven, Details A & B SK2424 Rev. A 6/09/2010...
- Page 21 PARTS LIST October 4, 2012, Rev A DO36 36” BAKE DECK OVEN Details A & B Fig No Part Number Qty Descr Application N9-LA36-116 VENT PIPE ASSY 2T-30402-07 STAT ADJ 550o 48 C/T 2E-30304-W35 SWITCH - 3 POS ROTARY (mounted w/2 screws) PS-60101-W3 KIT - 3 POS SWITCH REPL...
- Page 24 STAR INTERNATIONAL HOLDINGS INC. COMPANY Star - Holman - Lang - Wells - Bloomfield - Toastmaster 10 Sunnen Drive, St. Louis, MO 63143 U.S.A. (314) 678-6303 www.star-mfg.com...