Installation; Leg Installation; Stacking The Oven; Electrical - Lang ECOH-AP Installation And Operation Instructions Manual

INSTALLATION

Leg
Mounting Hole
4" Leg
Stacking the Ovens
Two alignment pins (pn:2C-20108-11) are needed
if you intend on stacking two ECOH
on each other as shown. The stacking kit
9Q-ECOH-SK must be requested at the time of
purchase, or call your Lang authorized service
agent, or Lang parts department
at 314-678-6315.
Having completed the previous step remove any
and all button plugs from the lower unit, so the
upper unit will lay properly.
Lay the upper unit on its back and screw the
alignment pins into the two rear holes.
With assistance lift the upper unit onto the lower
unit, being certain that the alignment pins go into
the alignment holes, as shown here.
NOTE: Each unit must have separate
electrical connections
Cardboard
16" or 28"
Stand
7

Leg Installation

4" legs are available for single
countertop installations. Single and
double deck installations require
16" or 28" stand installation, casters
may also be used in certain situa-
tions.
To install the 4" legs, place some
cardboard on the floor and gently tip
the unit onto its back. Fasten the
four, 4" legs into the threaded holes
located on the bottom of the unit.
Gently lift the oven into its operating
IL1430
position.
16" & 28" stand installation, after
following the assembly
instructions that were provided with
the stand, gently lower unit on to
some cardboard as shown here.
Align the stand with the bottom of
the unit and secure with the
hardware provided. With the
assistance of carefully raise the unit
to its vertical position.
IL1431
Alignment Pins
pn: 2C-20108-11
Alignment Hole