Table of Contents
Advertisement
Operation
After you have plugged the scale into a wall outlet using the AC
adapter, allow for at least 30 minutes' warmup.
The weight display shows the following special Status messages for
your Information:
BUSY
The scale processor is still busy processing a function and will not ac-
cept any other commands to perform functions at this time.
STANDBY
The display has been turned off with the ON/OFF key (8) and the
scale is now in the ready-to-operate mode so that it does not require
warmup.
POWER OFF
The scale was disconnected from line power (power failure or outage,
reconnection to line power after scale was unplugged).
CAL
The calibration function has been activated.
Turning the Display On and Off
Press the ON/OFF key (8) to turn the display on or off.
You can also turn it on by pressing the tare control (6).
When the scale is connected to the AC adapter and the power is on,
the display will go out whenever you turn off the power using the
ON/OFF key. All other electronic circuits will remain energized (indi-
cated by STANDBY). This means the scale is immediately ready to
operate without requiring warmup the next time you turn it on.
18
Hide quick links:
Advertisement
Table of Contents
