Panasonic KX-TA624 Installation Manual page 219

4.1.2 Programming Methods
Advancing to the next stage
Storing your data
* Confirmation tone (one beep)
* Confirmation tone (two beeps)
* Alarm tone (three beeps)
Making another selection within the same program address
Confirming the entries
Going to another program address
Returning to the operation mode
When "SYS-PGM NO?
desired program by entering the 3-digit program address.
Press STORE to store the data.
• The STORE indicator lights red and a confirmation tone is
heard.
After pressing STORE, a beep will be heard. This informs the user
that storing is completed.
This informs the user that the parameter has already been stored.
If this alarm is heard, the user's entry is not valid.
• To make the next selection, press NEXT.
• To make the previous selection, press PREV.
• To make a specific selection, press SELECT and then enter the
number.
The user may review the stored programming without making any
changes.
Press END and the initial system programming message will be
displayed.
The display shows: PITS-PGM NO? →
Then enter a program address.
You can go to the higher number program address by pressing the
button and the lower number by pressing the
the program title is displayed.
Display example: Date/Time Set
Set the MEMORY switch to "SET".
→
" is displayed, the user can go to the
program title
System Programming
button while
4-5