4.2
System Programming
Description
Selection
Default
Programming
Conditions
Feature Reference
SMDR Parameter
Used to match the SMDR output to the paper size being used in the
printer. The page length determines the number of lines per page.
The skip perforation determines the number of lines to be skipped
at the end of every page.
• Page length (lines): 4 – 99
• Skip perforation (lines): 0 – 95
Page length – 66; Skip perforation – 0
1.
Enter 801.
Display: SMDR Parameter
2.
Press NEXT to program the page length.
Display example: Page Length:66
3.
Enter the page length.
To change the current entry, press CLEAR and enter the new page
length.
4.
Press STORE.
5.
Press NEXT to program the skip perforation.
Display example: Skip Perf: 0
6.
Enter the skip perforation.
To change the current entry, press CLEAR and enter the new skip
perforation.
7.
Press STORE.
8.
Press END.
• The page length should be at least four lines longer than the skip
perforation length.
• The title is placed on the first three lines of every page.
• The programmed format becomes valid only if the Serial Interface
(RS-232C) cable is connected. If a printer is already connected,
disconnect it and connect again. Otherwise the previous format will be
used.
Section 3, Features
Station Message Detail Recording (SMDR)
System Programming
801
4-125